"Where Tradition Meets Innovation"
Contemporary Crown Moulding Corners
Inside 90 Degree Outside 90 Degree
Crown moulding can be a love/hate situation, you love the look of crown moulding but hate the thought of all the complicated compound miter and coping cuts. Well then, our crown moulding corners may be just what the doctor ordered. Based on the same principle as the rosette block, these allow the use of square saw cuts. Simply fasten the corners and measure the distance between each, then cut your crown and install. You're done in a third of the time of a traditional installation, with unique accents.
Crown corners are available for oblique wall angles (120, 135, 150, etc) as well as 90 degree. Please contact the Custom Shop for information.
Crown moulding corners are not available for vaulted ceilings.
In addition to crown corners we also offer matching splicers for breaking up long runs, and end caps for when you need to terminate a run.
Shown above with our "default" edge detail, these corners are available with a radius, chamfer or cove edge as well.
In order for us to make a corner that will fit your crown, we will require a few dimensions from your moulding, as shown in the image below. These measurements are critical, as are the spring angles where it contacts the wall and ceiling, therefore we ask that you send us a small piece of your crown so we can ensure the best possible result.
If you have any questions please call, or click on the e-mail link below.